Light tab/bar install

	Light Tab Mounting Taking pictures of the install is very difficult. A special thanks to Rob Smith for removing his bumper to give a better detail of where/how the tab mounts. Some pictures represent light mount tabs, some of them represent light bar mounting tabs. From the backside, slide the tab in the gap between the bumper and grill. Use the "high" part of the bumper. It is recommended that the tab is wrapped with blue tape to prevent any scratches to painted sufaces. Slide the bracket down to the lower level of the bumper. The pic shows the approximate postition of the bolt area. This shows the mounting points for the tab. Remove the bolt using a 13mm wrench and reinstall with the light tab. Ready for lights. The tab pictured are for light mounts. The tab is arched to fully seat the pro comp lights for a clean and professional installation:

	LIGHT BAR MOUNTING For light bar mounting, add the following steps: Light bar tabs are slotted and notched to accept all Light bars avialable form Underdog Simply bolt the bar to the tabs using the enclosed stainless steel hardware. The slots allow left to right positioning to perfectly center the bar. Extra washers are included and should be used between the tab and bar to level if needed. Spacers can be used to lift the bar above the tab. This can be used to fill the gap if a body lift is installed in the truck. Mount the lights and wire them up. Many comboinations are available between the 3 light and 4 light bars, including single and double CB antenna mounting, surf rod holders. They are made to order so communicate what you would like.